MPAXX 700 DRIVER

If the attenuator is made of more than one piece of foam those pieces must be glued together using a structural adhesive that is compatible with the Impax foam. The technical inspectors may choose to verify the dimensions and the material and have the authority to conduct any measurements, inspections or tests they feel are necessary. Deflections must be less than the Segments may not be stacked without glue. The drawing applies for the - competition year. There is no change from the Type 12 Impact attenuator.

Uploader:	Mibar
Date Added:	28 May 2009
File Size:	6.29 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	55930
Price:	Free* [*Free Regsitration Required]

Since the required testing is done with the attenuator crushing parallel to the vehicle axis mounting is really evaluated. Attachment methods are important for providing for impacts that occur at an angle.

Segments may not be stacked without glue. More information about the Dow Impaxx foam can be obtained from the Dow website at: Are we required to submit an impact attenuator data submission by the action deadline on the website? Deflections must be less than the Our test results indicated that the specimen satisfied the requirements of B3.

Impact Attenuator

Should we include pictures, dimensions or other information? What should be included in this submission? The Type 11 Impact Attenuator is approved for the FSAE competition season only and the minimum required design may change in future years.

How should this be handled with the standard design? There is one clarification, however.

The team should determine the best method of attaching the standard design to their vehicle. Is the mounting scheme shown on the part drawing the only allowable configuration? Yes, please see B3.

Dow Impaxx 700 Impact Attenuator - FSAE SAE Supra

The mounting shown on the part print is a suggested method that could mpqxx used. The technical inspectors may choose to verify the dimensions and the material and have the authority to conduct any measurements, inspections or tests they feel are necessary.

The drawing applies for the competition year. To address this, teams should determine, either by testing or analysis, that their configuration for front bulkhead and anti-intrusion plate can support the requiredN 26, lbf of load from the anti-intrusion plate assuming a uniform pressure applied load across the area where the anti-intrusion plate mounts.

The drawing applies for the - competition year. Teams should use good engineering practice and calculations to determine the best mounting method for their vehicle.

There is no change from the Type 12 Mpax attenuator.

Standard Impact Attenuator

If the attenuator is made of more than one mpxxx of foam those pieces must be glued together using a structural adhesive that is compatible with the Impax foam. These calculations or test data should be included in the impact attenuator data submission and should include predicted strength and deflections.

However, teams have the burden of proof to show their foam is the required material. Examples of good documentation include a receipt from that competition year, a packing slip or letter of donation.